• General Application Instructions
• Tips for Wood, Vinyl, and Aluminum Siding
• Concrete and Masonry
• Deck and Patio
• Kitchen and Bathroom
• Attics and crawl spaces

General Application Instructions:

1. Apply MoldAvenger using any of the following methods: MoldAvenger Spray Bottle, MoldAvenger Hose Attachment, pressure washer, other type of high pressure equipment, pump up garden sprayer (chemical sprayer), atomizer/fogger, bucket and sponge, brush, roller, etc. Agitate (scrub) the surface with any kind of scrub brush, broom, or toothbrush. This will help work the enzymes into the surface for a deep clean and help with the removal of tough stains.
2. Allow MoldAvenger to sit for 15-20 minutes
3. Rinse with a garden hose, pressure washer, or simply wipe off surface with wet cloth or towels for interior applications.
4. If you are painting over the treated surface, simply allow the surface to dry after rinsing MoldAvenger form surface

^ back to top

Tips for Wood, Vinyl, and Aluminum Siding:

1. For large areas, the MoldAvenger Hose Attachment, pressure washer, or pump up garden sprayer is the easiest application method.
2. Agitate areas of heavy build up and allow the recommended dwell time.
3. Vinyl and aluminum have a tendency to stain more than wood. Strong agitation and a rinse with a pressure washer or high pressure hose will help with tough stains.

^ back to top

Concrete and Masonry:

1. Concrete and masonry are very porous which allows mold and mildew spores to penetrate deeper into the surface. For best results, after applying MoldAvenger scrub the surface to work the enzymes further into the surface and rinse with a pressure washer or high pressure hose.
2. Re-application may be beneficial in ares of heavy growth.

^ back to top

Deck and Patio:

1. Horizontal surfaces are problem areas for mold and mildew. The easiest application method for these areas is a MoldAvenger Hose Attachment, garden sprayer (chemical sprayer), or for small areas a MoldAvenger Spray Bottle.
2. Apply MoldAvenger liberally and agitate with a scrub brush or deck broom. Agitation will help MoldAvenger to penetrate through the built up layers of grime to get to the problem area on the surface. Allow the recommended dwell time and rinse with a hose or pressure washer.

^ back to top

Kitchen and Bathroom:

1. Most problem areas in kitchens, bathrooms, and other interior spaces are fairly small and localized. The MoldAvenger Spray Bottle is the easiest application method for these problem areas. However for larger interior applications a pump up garden or chemical sprayer works extremely well.
2. Apply MoldAvenger and agitate with a scrub brush or tooth brush, allow the recommended dwell time and wipe away.
3. Mold and mildew are extremely hard to remove from caulking. In severe cases it is best to replace the affected caulking.
4. MoldAvenger is safe to use on or around surfaces where food will be prepared.

^ back to top

Attics and crawl spaces:

1. These problem areas are difficult to treat with bleach based products due to the toxic fumes produced in enclosed, poorly ventilated, areas. MoldAvenger does not produce any toxic fumes and is a safe and effective solution for these areas.
2. MoldAvenger can be applied with a spray bottle, pump up garden sprayer or chemical fogger, or fogged.
3. MoldAvenger should be applied to the affected areas, scrubbed, left the proper dwell time and wiped or rinsed from the surface.
4. Fogging MoldAvenger is an effective method for treating airborne spores, odors, or treating very large areas where additional moisture is unwanted. This is also a very popular method to clean ventilation ducts in highly contaminated areas or where there has been fire or smoke damage.

^ back to top